...Hyundai coupe with an autobox. The problem I am having is when you put it in drive it pulls away as normal but then as you pick up speed flicks back to neutrel and sometimes cuts out as a result. It ...
...how do you remove a gearbox cv joint on a hyundai accent si coupe It just pulls out of the geat box, it has a internal snap ring, they can really bwe a bear if they're being pulled for the first
Hyundai Coupe gearbox ( not car in product) Hi. My Hyundai coupe se 2L auto gearbox is faulty. It is a 97 R reg. It will drive in 1st but stays there, also the reverse has no response at all. I have a
...Hyundai Coupe 2.7L V6 clutch problem Hi I have a small problem, I have a Hyundai Coupe GK 2.7 V6 (2002) that I have replaced the engine on, assembled everything ? and now found out after starting it ...
...hyundai accent coupe e and my clutch started squeeking when the pedal was pressed so i put wd 40 on the joint that goes into the rubber plug into the gearbox but it may have gone in the rubber plug ...
...My 2000 Coupe 2.0 has developd a bearing noise/vibration from the gearbox area, is this something that the model is prone to? Since you believe it's a bearing, replace it.. then see if you're
...Hyundai Accent Coupe (2000) and yet the thrust bearing is still noisy and it is notchy going into 2/3 gears and when dropping down from 5th to 4th - any ideas? Many thanks, Chris if you used the car ...
...hyundai coupe se 1998 Sounds to me like u have a faulty ( pulse generator sensor) u can find it at a dealership for less than 80 dlls. it can be easly replace by anyone its : a 1 plug conector wire ...
...hyundai s111 coupe 2.0L 2007 5 speed can you help me thanks not sure if you can interchange the manual & aut shafts, but you should check to see if there is excessive play where the shaft enters ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions