...reduction of undesirable exhaust components. -------- It's a good article about the two-sensor system and oxygen sensors in general and is available here: ...
accent engine light I had the code read and the first indication was a bad gas cap (gas vapor system). Replaced the cap with on resolve. Had a good mechanic read the code (can't remember the code) and
...oxygen sensor located on the hyundai atos(santro xing) follow the exhaust pipe from the motor. i beleive it is before the catylitic converter. screws into the side of the pipe and there are wires ...
...hyundai accent stalls or just turns off when slowing down. I'd like to do the tune-up myself if at all possible. I've already done the fuel filter (and can do the air filter, sparks and cables.) What ...
...accent is sputtering, changed ht leads and plugs still got issue, any body know what might be the problem, ticks over fine but soon as engine gets warm it is sputtering and dying, Did you gap the new ...
Question about 2000 Accent
...Hyundai Accent to find out if it is working properly? I keep getting error code P123. I have changed the oxygen sensor, but still keep getting the same err I reset the OBD ll sensor after reading the ...
Question about 2000 Accent
Hyundai Accent 1.5 L, and the check engine light keeps coming on. I have read the codes on OBD II and found that it is P1123 that is the only code that shows up. I have changed both oxygen sensors and
oxygen sensor Where is the downstream o2 sensor located normally on the outlet end of the cat converter. The heated o2 sensor is prior to the converter.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions