Questions & Answers for: husqvarna lawn mower wont drive

wont budge along with the brake pedal... Drop mower deck and have a look. Both rods run to the rear on the right side. Possibly something interfering. The forward/reverse pedal is stuck in the forward

...husqvarna yth 150 runs fine goes up hills plenty of power after running for while starts loosing power wont go up hills will stll move on flat surface Hi, it sounds like the hydrostatic drive is ...

wont go into drive mowing grass, everything just fine, felt slight thump then mowere would not drive (forward or back). can't see any visible damage or loose part. check the drive belt

wont pull transaxle broke, replace both sides, and new drive belt, will mow fine, slower than normal does not want to pull up even the slightest incline Make sure the drive belt is routed right. Go to

Husqvarna CTH140 wont drive. Belt seems fine but is continually spinning even when in neutral. Whines as though drive is engsged but nothing at the axle. Any ideas ? Low oil level in the hydrostatic ...

Unit wont or moves very slow on lawn. did you check your belts? if its a hydro drive it may have bad trans axle

zero turn rz4623 won't move wont drive ??? check the belt, check the fluid, check the dump valves wont push, check the brakes and the dump valves

...wont move , then id go on to look at drive belt , there's a little plastic fan u can see thru crack in back plate it should turn with engine (Pto not required) other than that id look at shift lever ...

MOWER WONT MOVE Drive belt broken or slipped of pulleys, hydrostatic drive filter(s) plugged. Should be one or those, Roger. Follow the drivebelt with your hand (disconnect battery to be safe) and see

...wont engage Hi Mary: The drive belt will possibly have slipped off a pulley. With the engine OFF, look between the cutting deck and the underside of the machine. Check the position of the belt as you ...