Questions & Answers for: husqvarna chainsaw tools

clutch drum How do I get the clutch drum loose from a husqvarna 136 chain saw? What tool do I need to get it loose. Thank you here is a breakdown of that saw ...

husqvarna 371xp chainsaw so i can replace the bearings? there is a special tool to seperate the carnk case halfs.looks like a "c" clamp.they are very expensive to buy.there is no other way to seperate

how to change a cluth on a rancher 455 chainsaw eReplacementParts.com : Power Tool Parts and Tool Repair

...Husqvarna chainsaw that starts find and runs for a few minute. then acts as if it is not gettting enough fuel as it starts to bog down while running and will not maintain idle. It may well just need ...

need warranty registation Here is site to register your tool: Husqvarna Good luck Thanks

special carb adjust tool for Husqvarna 240 e chainsaw Take a look on amazon... here Amazon com Husqvarna 240 carb I'm pretty sure you can find something. I hope this was helpful. cheers

chainsaw clutch removal I'm trying to remove the clutch from my Husky saw so that I can adjust and service the oiler. How do I get it off? All Husqvarna chainsaws have the clutch spun onto the

...tool is required to adjust the carb. on a 142e husquvarna chainsaw? there are no slots in adjusting screws for a flat head screwdriver ...

...husqvarna 240 chainsaw The tool required is part no. 530035560 it fits onto the splined jet screws. Check the web for prices etc. The splined Poulan Carb Adjustment Tool, 530035560, which was readily ...

...husqvarna 240 chainsaw Use an air gap tool. Clean the area where the coil mounts on the engine with emory cloth to make sure you get a good ground. install the coil and lightly tighten screws (just ...