Questions & Answers for: hunter thermostat control

...Hunter Thermostat We have recently moved into this house, and have found that the temperature is fluxuating wildly. Even though we have programmed the thermostat, it heats up certain "zones" (we have ...

hunter 44360 thermostat wiring I currently have a Von Air digital non-programmable thermostat controlling my Trane electic a/c and heater. Where do I put the wires on a programmable Hunter 44360. ...

...Hunter thermostat that controls both my air conditioner and heating system worked fine for a couple of years. Then the date and time started getting out of whack. I replaced the batteries..problem ...

help programing the thermostat in my house. Hunter, md 44550 I would like some help programing the thermostat in my house. Hunter, Model 44300A Thanks, Thermastat is stuck on hold, how do I get it off

Hunter digital thermostat. It was working prior to installing the new t'stat. Thanks not all digital thermostats are compatible with the manufacturers circuit control boards in the furnace. Hunter has

...Hunter thermostat, but I'm not positive the thermostats (both?) are the problem, and I haven't seen any traffic online about the Hunter in a 2-zone setup. I know the compressors are ...

...thermostat setup: The 44134 model from Hunter doesn't feature a terminal in the back plate for the "C" wire for that. (The blue wire from my Goodman heat pump is the "Comm" or "C" wire--that's very ...

...Hunter 44665 thermostat with remote sensor. I can read the temp on the sensor but it should be able to control the main thermostat. I just don't know how it is supposed to work. I have tried ...

hunter model 4409. How can I reset? Reset hunter model 4409 - Fixya www.fixya.com/support/t26079594-reset_hunter_model_4409 34 mins ago - reset hunter model 4409 - Hunter Set and Save Programmable ...

...Hunter 44905 thermostat Can you tell me where my four wires goes into the hunter, from the wall is red,white ,green and blue. Unfortunately, the time to check where the wires go was when you removed ...