Questions & Answers for: Jeep Wrangler hot keys

No spark from ignition module on hot start There is no spark from the ignition control module (as inidicated by pulling the center distributor lead) after the engin is shut off for abour 30 minutes, ...

...over everything is hooked up correctly and still nothing but a loud clicking noise and battery gets hot sounds like the starter is bad tap the starter with a hammer while someone else cranks key they ...

...pickup and anything along that line ...also make sure that the run side of the ignition switch is hot with the key

...side of the ignition switch is not working. When the key is on run position the same wire that is hot coming out when the key is turned to accessory should be hot, along with the ignition wire that ...

...that is random, most of the time it happens 2 to 3 times a day and doesn't matter if engine is hot or cold or if I use the remote starter key. Turn the key and it just clicks one time, turn the ...

For 1992 Wrangler, manual transmission, able to jumper across the hot and start connections on the solenoid to start the truck, but nothing when the key is turned. The problem is in your ignition ...

..."turned off". there was also a strong sulfer smell and the battery was buzzing and very hot to the touch. I disconnected the negative battery terminal. What is going on? probly need a new ...

93 4.0L wrangler blower motor works when hot wired direct. No voltage at heater fuse mini-fuse box under dash? Where do I track voltage backward from there? The 25amp blower fuse is powered thru the ...

... (rules out battery and charge system in 1 act) so the starters bad or the key line is dead. so you hot wire the starter solenoid and bam cranks. so the starter was good, just 1min test with ...

...path on all cars is head lamps.
but fuse 10 runs head lamps via a circuit breaker
Fuse 10 is hot all the time.
if that's hot and fuse cb is hot, the Heads work.
8w-50 page, covers that. ...