Questions & Answers for: hose connection

hose connection, 2 others on the fuel ****: 1 fuel hose, 1 vacuum hose - 4 carburettors: Seen from the back: 1 fuel inlet on a common ramp at the back, 1 vacuum connection between the two center carbs

connection, a broken hose, a cracked component, or a defective seal. It could also be a hole in the tub. If a hole in the tub is the problem, it's usually best to replace the washer. Most leaks can be

from the heater connection and connect that hose to the other hose connection at the engine. Take the free end just removed and connect it where the first hose connected at the heater. Hope this helps

where does the overflow hose connect to? OVER FLOW HOSES YOU HAVE THREE HOSES THE 3/4 INCH HOSE CONNECTS TO TO RADIATOR TWO SMALL SURGE HOSES ONE CONNECT TO TOP OF RADIATOR THE SURGE HOSE GOES TO ...

hose connection. Unfasten the three water inlet connection retaining bolts and remove the water hose connection. Remove the gasket and thermostat from the water hose connection. Discard the gasket. To

...hose connection and the thermostat assembly - 3.0L OHV engines (click over pic for zoom) Drain the coolant until the level of the coolant is below the level of the thermostat. Disconnect the upper ...

...hose connection that was supplied with your unit, to carry water to the drain. 1. Remove the drain-hole cover on the back left side of your unit. 2. Connect a garden hose to the threaded drain hose ...

...Hose Connection is on the left side of the water collection bucket. You may have to carefully drill a 1/4 " hole in the center of the connection, once you unscrew the drain cap. The hose should be no ...

...connected to valve---tighten hose connection 2. Drain hoses not tight on pump----tighten hose clamps 3. Broken hose---replace hose 4. Leaky gasket---replace gasket 5. Cracked housing---replace ...