Questions & Answers for: hoover rewind overheating

NO POWER WHEN I PLUG UP THE VACCUM I was using the vaccum and it just quit working. There were no smells or wierd sounds when it happened. This vaccum is only 3 months old. Any ideas what's wrong? I ...

...run points are not breaking at speed and so the start windings are overheating and causing the breaker to trip Take it to an electrical motor rewind shop and have it properly tested with test ...

...Hoover wind tunnel keeps overheating and the red I dictator is on. I have cleaned all filters and checked for clogs....could the motor have dust in it? How do I check? Okay.  I read these posts ...

it's likely a problem with the cord rewind. Some of those units had a recall on the cord rewind. To find out for sure find a local hoover service center and take it in for repair many times at no cost

I used the vaccum twice and each time the vaccum has turned off and will not turn back on. We've switched outlets and still will not turn on. It is the Pet Elite one. If the filters are clogged or ...

possible problem with thermal indicator? My vacuum keeps on shutting off after a couple of minutes. I did some research and it said it was overheating. I went through all the troubleshooting; put in a

...over the motor. Overheating motor causing an automatic shutoff. This is most commonly caused by an air passage that is plugged by hair or dirt. Hoover WindTunnel 2 Rewind Troubleshooting - iFixit