...Honda Civic "dies" driving along under no unusual load. No codes are thrown. Computer reset. Went on for a few months then had fuel filter, plugs, wires, dist , rotor have been replaced, throttle ...
car cranks but does not start. code 89 appears on ecu Check for the crankshaft position sensor and top dead center sensor inside the timing belt cover, they might be dead.
honda civic ex 110000 miles towed car home pulled plug and wire and check for spark but nothing all though the gap on the plug looked fairly large Note: very little maint has been done on this car any
...honda civic took it to autozone and had the check engine light checked and it came back witha p1361 code anybody no what a tdc 1 sensor circuit is TDC top dead center sensor. Tells when the #1 piston ...
honda civic reads a code P1362. what does this mean engine light code P1362 problem P1362 = TDC (top dead center) sensor (1) no pulse. Reset your car's power control module (PCM or ECU) by turning off
...civic. You have to take the cover off to get to it. Honda dealer wanted $360 in labor to change the sensor. Because it was in the same the location Honda would have changed my timing chain for no ...
...cover, you have to take cover off to get to it. on 2001 honda civic. take off top timing belt cover, about half way down the cover is the connection for the tdc sensor, check the connector and
honda civic codes p1361 & p0113 along with gas smell When engine there is a strong gas smell and poor gas mileage along with the DTC codes P1361 and P0113. P1361 HONDA - Top Dead Center Sensor 1 ...
code 1361 on honda P1361 Camshaft Position (CMP) Sensor A (Top Dead Center (TDC)
90% of the time, this is the problem. It is such a prevalent problem I used to always keep a spare "dizzy" in the trunk to bail out my fellow Honda nuts when they ended up dead on the side of the road
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions