...Homelite--which turned out to be the location of the carburetor lower-chamber gasket. The diaphragm needs to go to the carburetor body (pin inward), then the gasket and cover plate. Go to: ...
Question about Consumer Products 9.0 Amp, 14 In. Chainsaw
...homelite 290 chainsaw not start? why will my chain saw not start? it has sucessfully cut down 3 trees, and has now refused to start again! Make sure you have blue, snappy spark at the plug (set at ...
Question about Consumer Products 9.0 Amp, 14 In. Chainsaw
Homelite 10540 chainsaw 35CC chainsaw won't start when hot I have a Homelite Model 10540 35CC chainsaw; it starts fine when cold, but won't start when hot. Why. Go to: http://www.drystacked com for a ...
Question about Consumer Products 9.0 Amp, 14 In. Chainsaw
I need to prim my saw to start it & is very hard to start?? Go to: http://www.drystacked.com for a 12 page article on Walbro brand carburetor theory and troubleshooting. Pay particular attention ...
Question about ZR10580 FactoryReconditioned 42cc 18" Gas Chain Saw
...homelite 42 cc chainsaw. wat could it be ? Try pouring a small amount of fuel mix into the spark lug hole and try for start. If it pops several times, then check the fuel filter, air filter, and ...
fires but will not continue. fresh gas, plug's ok. ??? Does the primer bulb fill with fuel after several pumps? Check the fuel filter, air filter, and muffler for plugging. Check the condition of the ...
Homelite 240, runs but shuts off......... I suspect carburator..... Check the fuel filter, air cleaner, and muffler for plugging. Inspect the fuel lines for decay or other damage. Make sure the ...
Question about FactoryReconditioned ZR10522 46cc 20in Gas Chain Saw
...chainsaw starts nicely,but when you try to give it gas to cut it cuts off.It will restart immediately but cut off again when given gas?What's up with it? Check the fuel filter, air cleaner, and ...
Question about FactoryReconditioned ZR10522 46cc 20in Gas Chain Saw
...and choke, It still will not start. What can I do? Thanks, William You might want to refer to the troubleshooting section in the Homelite UT60526 Manual. The troubleshooting guide starts at page
Question about Xl-98a, Xl-98c, Xl98-d, Xl98-e Cut-off Saw Air Filter Gasket 50951
homelite xl-98c will not start I have changed the sparkplug and still cant get homelite xl 98-c Changing a spark plug rarely fixes a no start problem. You need to troubleshoot the saw more. Do a ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions