Questions & Answers for: homelite chainsaw runs dies

homelite chainsaw mod 4620c will start and windup and die Sounds like it is getting lean (running out of fuel) then dies. Clean and inspect carb and fuel lines.

...homelite 16'' chainsaw dies out after about 10 cuts (5 min). I have to wait an hour or so before it will start again? Is it just overheating? (I use the recommending fuel/oil mix and proper bar chain ...

Homelite chainsaw won't stay running I have a Homelite Model: UT109470 chainsaw which does not stay running. I put in a new spark plug and got it started, used it to cut down a few branches, then it ...

homelite chainsaw runs for about 3 seconds and then dies... Are you using the choke and setting the fast idle? Make sure you have 50:1 fuel-oil mix in the fuel tank and that the fuel can is thoroughly

my homelite seems to running right until i cut into wood then the engine just dies for some reason Not right ideal settings!

Homelite XL2 rebuilt the carb still dies after a minute or so then won,t start. let it sit for fifteen minutes then starts up. Runs on wot only. Tweeked the needle valve lever, did not change. hard ...

Will not stay running Replaced failed primer bulb, cleaned carb. Will start run a few seconds and die prime it again and will start but shuts down in less than a minute Not adjusted properly.

homelite chainsaw dies after running a few minutes Carburetor problem.

...homelite 3316C gets hot it stops running. What part do I need to fix this problem? nothing First make sure cylinder fins are free of debris; otherwords, good air flow around the cylinder. Second try ...

Homelite super 2 chainsaw runs fine for first 15 minutes and cuts well in big wood but after first 15 minutes dies wont hardly even start again unless fillup with gas and same thing in 15 minutes fuel