...hold down the start button. Any suggestions? 3 seconds- end of cycle button I have a whirlpool duet HT front loading dryer that makes a thumping noise @ high spin drying. Is there a troubleshooting ...
maytag dryer won't keep running push the start button and have to hold it to keep it running but it still shuts off in a few seconds. Maytag dryer model de412 series 07 poss the starter relay.
...hold button and will run for a few seconds, but then stops totally. We were able to get it going for one cycle, but not will not start again at all. Thanks for any ideas... when I push the start ...
Question about Duet GHW9150P Front Load Washer
...button and then hold both down for 10 seconds it will power up again. When it shuts off I have to do all of the above again(sometimes several times before I get results). It seems like it may have a ...
hold the button in. When it sits a bit you can do it all over again as it resets itself. If you push the start and let go immediately it shuts off . sounds like your start button is shorted check this
Question about AEQ7000EG Affinity Series Electric Dryer
...button. * Wait 5 seconds. * Press and hold the Start and Pause/Cancel buttons simultaneously. * All LED’s will go blank and after a few seconds the control will signal the stored code using audible ...
few months) the dryer will not start. The panel lights and controls function correctly. When the start button is pressed, the motor starts for less than 1 second and then stops. If the start button is
Question about AEQ7000EG Affinity Series Electric Dryer
few months) the dryer will not start. The panel lights and controls function correctly. When the start button is pressed, the motor starts for less than 1 second and then stops. The panel lights flash
Question about GTDP180GDWW Gas Dryers
...hold in button door switch and hit the start switch to get it too run a few seconds. Watch the drum and see if it turns. My guess it will not. Belt is a long skinny band that goes all around the drum ...
Question about GTDP180GDWW Gas Dryers
...Hold POWER button for 5 seconds and press START], plug in the dryer and press START again and it work normally about 50% of the time. I have checked and cleaned the dryer filter and vent. I don't ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions