Questions & Answers for: hobart dishwasher element wiring

Hobart LX30H Parts If I can not get the scale off the heating element I might need to replace. Also the wash arms had rubber plugs on the end and they are gone can I get them replaced or should I just

booster heater not heating We have a am14c dishwasher,two elements went bad,one was leaking which caused sparks to fly out.I replaced the 2 elements but the heater does kick in,have voltage ,how do I ...

hobart dishwasher lx 30 h will not heat to 180 in the rinse cycle or wash cycle Did the clean light indicator blinking over n over? check the element wire harness connector. If disconnected fix it and

hobart LX dishwasher rinse cycle only heats to 145 degrees. It is about 6-8 years old. Any suggestions? 145 degree is just your hot water temp and that your dishwasher hot water booster is not working

...element on a hobart am14 while replacing the element I noticed only two wires goto the three loops for the heater element. the loops are attached by jumpers to complete the circuts. the left element ...

incorrect wiring on a heater element for a hobart am14 Is this single or 3 phase? What happened?I'm a hobart tech.

...HOBART AM14C Dishwasher CON 3 keeps banging away(on off on off)..no heat on rinse cycle sometimes, but when we do it drops off after first load...I am thinking element in the booster tank and or ...

...hobart for the home it likely has an element. The element will not be on for the drying if you are on economy mode Perhaps it will not heat the water in that mode either. If it was supposed to work ...

Hobart LXIH !The booster is not getting to temperature! we change the temperature sensor probe , and still nothing! the booster contacter not getting activated! if i push down the contacter i get ...

...Hobart AM15 dishwasher is displaying an AH error code on start up, it usually indicates that there is an issue with the booster heater. AH stands for "Booster Heater Circuit". Here are some ...