Questions & Answers for: highest pressure radiator

...highest setting. So why is my radiator over pressured? It might of just been a defective hose because if the pressure gets to high, the radiator cap will relieve the pressure when it reaches the ...

system mill cause leaks everywhere. Even on new parts. Check radiator cap for gunk and make sure pressure valve is working. The highest pressure for cooling systems should be 17 psi and not any higher

...highest point. Open each one while the system is pressurized and let Air escape until some Coolant escapes. Sometimes it may be necessary to loosen a Heater Hose and bleed the air at that point. ...

...pressure. Drain engine coolant from drain plug on radiator. With the drain plug removed disconnect the highest hose connected to a radiator. use an hosepipe and put it in place of the disconnected ...

pressure relief valve on the side. If the air is in the loop (baseboard or radiators) then you should go to the highest point in he loop & bleed the air out using the bleeder valves on he baseboard or

...pressure. the cooling system will not fill completely if the bleed plug located @ the highest point of the system up is not opened when you are filling up..that plug could be @ the radiator , but ...

highest point :) it may take several attemps,but in the end it works. Could be a blocked or partially blocked radiator. Radiator cap may not be holding enough pressure. Coolant solution maybe to weak.

...pressure to let out air till you feel cold freon coming out. Have the motor running and the AC on its highest setting while putting in freon. WARNING discarging freon into the atmosphere is illegan ...

...take it to a radiator shop and have it pressure purged you might try selecting the highest hose point , and loosing the hose off until only water comes out ( cold process only)--- heater system ...

...pressure Not sure what you are working on, but make sure that the engine block is properly burped of all air. Most newer cars have a bleeder valve located at the highest point of the engine to allow ...