Questions & Answers for: high rpm slow acceleration

Question about 1992 LeSabre

2 Answers

...high rpm 1992 buick lesabre- the car idles at about1000 rpm, when I accelerate it is very slow and the rpm hovers around 2000, it will not drop unless I ease off the gas a bit or push it to about ...

Ad

HIGH RPM PROBLEM - RPM won't pull back when foot taken off accelerator when coasting. RPM will match the running speed of vehicle. and stay the Still searching the right answer on Jag S TYPE- HIGH

Ad

...high rpm slowly and will sound OK. On the road stepping on the accelerator harder just makes it cough, buck and slow down. Your injectors are clogged. first check for codes, since it has individual ...

...high rpm no code At a slow steady speed the engine runs good when accelerating fast the engine misfires. When the engine misfires at high RPM the truck vibrates. Up a hill is when the engine would ...

Question about 2008 Silverado 1500 2WD

1 Answer

high RPM without shifting out of first gear, then eventually shift into second gear at about 3500 RPM's. check tranny fluid level,if good,either pump in tranny is bad or cluthces in tranny is gone bad

...high RPM on startup, then ... Engine Rev's high, slow to accelerate - Ford Truck Enthusiasts Forums www.ford-trucks.com > ... > Expedition & Navigator Aug 22, 2003 - Engine Rev's high, slow to ...

...revolutions or to high an idling rpm The idling speed screw should. Located near or upon the throttle. Butterfly wind either in to slow the engine or out dependant upon the make and model of ...

...HIGH screw until the engines RPM slows a bit. When that happens Turn screw back in until it revs high and then just starts to slow again. You do not want the engine to run at it's highest RPM or it's ...

...has replaced carbs with new factory. New plugs, New fuel , any ideas will help indicates a fuel flow problem at high rpm check for venting problems at tank cap or damaged fuel hoses to the ...

Question about 2002 Infiniti QX4 - All QX4 models - Xtreme White Bulbs

1 Answer

...RPM GOES TOO HIGH. Get the rpm's to around 2000 to 2100 rpm's and the rpm will up to 5 to 6K and then drop ..... I have clean the Idle CONTROLLER and bought new gas peddle. have any clue? FORGOT TO ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...