...heavy paper? Thank you! HP recommends papers with ratings of at least 90 for brightness and 75 g/m2 (20 pound) weight. before u proceed....remove the rear access door to reveal the rollers.Take a ...
heavy the paper could be. Sorry I cannot be anymore help but try using a paper that is about 10-20 gsm lighter. Thanks J This 1220 C printer is designed to print on greeting card paper and heavy photo
Question about Stylus CX5400 All-In-One InkJet Printer
...paper Can the paper feeder be adjusted for heavy weight paper? Hi , No You cannot there is limit for the printer to take on the paper , For heavy duty printer you need to check on some other
Question about imageCLASS MF5770 All-In-One Laser Printer
...heavy paper*, etc., the copy speed may be slightly slower than usual. *The paper type should be selected in the Menu. If you intend to make a copy and print with a thermal transfer printer using the ...
...heavy paper", like the Cheap, "dollarstore type", it's too Heavy for most Printers. try looking into the tray, and make sure there is not something in there,You'd be Surprised!, if there isn't ...
Question about imageCLASS MF5750 All-In-One Laser Printer
PAPER] -Heavy paper (25 lb to 34 lb (91 g/m2 to 128 g/m2 )): [HEAVY PAPER], [HEAVY PAPER H]*1 -Transparency: [TRANSPARENCY] -Label*2 : [HEAVY PAPER], [HEAVY PAPER H]*1 -Envelope: [HEAVY PAPER], [HEAVY
...heavy paper message When I send a document to print I have to manually walk over to the printer and press the check mark because it says '' manuall feed heavy paper'' . Would like to print ...
...heavy stock the paper/stock never adheres to the transfer drum sheet as if there isn't enough charge to hold the sheet to it. Any ideas of where to troubleshoot from? I have already set all ...
...heavy paper I need to print on heavy paper and it says to add paper to the drawer You may have to use the manual feed tray on the side of the copier. It is not designed to run through the paper tray, ...
...heavy paper card) The mx2300n only supports up to 209gsm heavy card. You must make sure that your heavy card is not over this rating. Set the bypass tray as 'Heavy' by clicking on the trays on the ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions