...display panel??? the control may be locked. another issue might be a broken heater plate, not a very home owner freindly part to change( heater plate has a fuse inline that would kill power to ...
...heater plate in the bottom of the drawer acts as a dropping resistor in the power supply circuit. The main computer is often replaced incorrectly when the the machine is "dead". The correct procedure ...
...the lid closer, they work although two had ohms of 199 and 302 which were on the top draw. Checked the other boards can see no problems the heter plate has a fuse molded in it change the heater ...
Question about 23 in. DD-603SS Built-in Dishwasher
...heater plate. Is this something i can replace myself? Thanks Al Arnold [email protected] SORRY, i WOULD NOT TRY THAT ONE ON MY OWN. lET THE SERVICE GUY DO IT, IT MIGHT BE MORE THAN JUST THE HEATER ...
...heater plate replacement My bottom drawer has no power . There was a burning smell and I had to force open the bottom drawer. I removed the control board from the bottom panel and discovered that it ...
...heater plate or the machine's controller. The heater element relay can be energized in the diagnostic test mode, and if the heater does not come on, the heater plate can be tested with an ohm meter. ...
...heater plate or motor seals, or drain o-ring seals. â?¢ Yoke jammed or broken. â?¢ Inlet hose to inlet valve connection loose. â?¢ Inlet valve body leak. â?¢ ...
Question about DS603SS Stainless Steel Built-in Dishwasher
...heater plate blew (when the heater shorts out it often back feeds to the board and fries it, can be a little pricey to repair over 300 easily, but the control board can die for no specific reason or ...
...in top and still nothing You also need to repair the solder link (over-temperature fuse) in the heater plate (or replace the whole heater plate). The drawer control board gets its power via that
Question about 23 in. DD-603SS Built-in Dishwasher
...heater plate has over heated and has burnt out, an over temperature thermo cutout. The controller is approx $130.00 (nz$) and can be changed in under 1/2 hr by someone who knows about these. If the ...
Usually answered in minutes!
809 Questions
201 Questions
174 Questions
104 Questions
87 Questions
