Questions & Answers for: heater controls

...heater controls Here is a link to the manual for the RS4. you cant run the control of the heater(except raypak heaters and lx from jandy), how ever you may turn on and off , depend on the heater you ...

...Controls Code Description P0001 Fuel Volume Regulator Control Circuit/Open P0002 Fuel Volume Regulator Control Circuit Range/Performance P0003 Fuel Volume Regulator Control Circuit Low P0004 Fuel ...

...CONTROLS OF THE ENGINE. TRANSMISSION OR EMISSION CONTROL SYSTEM, IN ORDER TO HAVE ANY HOPE OF FINDING THE ROOT CAUSE THE DEALER MUST TEST THE SYSTEM WITH A SPECIAL SCANNER TO SEE WHAT TROUBLE CODES ...

I have change heater control on the dash (3) times and can not get the heater to change from the vent ( in the face) to defrost or any other control Check the heater door linkage and cable adjustments

...Controls Code Description P0001 Fuel Volume Regulator Control Circuit/Open P0002 Fuel Volume Regulator Control Circuit Range/Performance P0003 Fuel Volume Regulator Control Circuit Low P0004 Fuel ...

We just installed a new Raypak 400k BTU cupro nickel NG heater. It's connected to a Jandy PDA controller. If I set the temperature above 86 on the PDA, the heater will cut off at 86. If I take the ...

fan blows, but heater display doesn't light up. blows out cold air only. no heat Check fuses to the A/C or Heater Control Unit in the fuse box(es).IF none are blown, then may have to replace ...

1998 mercury grand marquis heater doesnt work only cold air comes out the air cond works fine the enginecoolant is new, the engine doesnt overheat. Either your heater control valve is not properly ...

...does not react to presets. it is as if both thermostat controls try to control the heater. Does the external control interface need to be enabled? What is the problem. must put heater in tstat ...

...heater controls. A vacuum line from the engine is also there, the pod will send the vacuum signal out to various doors on the heater/AC case, as the controls demand. One also goes to the heater ...