...hazard flashes.I checked all fuses and they are good Under the dash is a flasher unit. Replace it and everything should start working again. The flasher unit is very inexpensive and available at most ...
...to replace the flasher unit which is located under the dash on the drivers side. put on the hazard flashers to make locating the unit easier (by sound) robert please take a moment to rate this ...
Question about 2001 Grand Cherokee
...and hazard unit.It will need to be replaced.its small and cost is minimal.When you do replace the unit,disconnect the neg. cable from the battery.The unit relay may be blue in color.Hope this ...
unit, also the hazard light wont work as well. ther is a single unit for signall ligths and hazards, the unit is faulty, but do this just for chance, press and release the hazard button few times then
unit causing this.you say hazard/flasher not working.do you mean just the signals not working and think the hazards won`t work or are the hazards not working.there are two flasher units one for signal
Question about 2004 Impala
...unit flasher, hazard switch and all fuses are good. i can hear the signal lights when i turn it on in left or right position and the lights come on outside but they dont blink. also the hazards wont ...
Question about 2004 Impala
all one unit built into the hazard switch in the center of your dash. Usually the hazard switch goes out on these. Replace the hazard switch and your turn signal and Hazards should work properly again
Question about 1998 Escort
...hazard and indicator switch. The unit should have an ignition supply to it as well as a perm ant supply when the hazard switch is pushed down. Sometimes these switches get sticky contacts so if you ...
Question about 1999 Falcon
why is my hazard lights stay on, no flashing just on all the time I have tried pressing the hazards button a few times & checked the fuses mst of the models you have 2 flasher units, flickers and ...
...Replace the hazard swirch. I know on the Jetta, the hazard switch/indicator unit were all in one part of the hazard switch. Pull it out, unplug, plug in another one and see if it solves the
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions