...motor connector to the main wire harness and turn the FRE/REC switch to "REC". Hold the air door closed, then connect the control rod to the clip on the arm. Email Me at the nickkname shown here ...
...motor now no spark ! replaced distributor w\coil, replace main relay under the dash {still nothing}. Turns over good just no spark. coil gets power in and out but not out the spark plug wire????????? ...
...harness from a 1991 honda accord fit with a h22 engine? That depends on what motor your accord came with, If was the f22 it does work but requires some mods. Providing that the vechile you are ...
motor it is? most lykly f22b I just did or am finishing vtec swap in my 91 accord firing order giving me problems I used 91 cap and rotor and wiring harness.any suggestions get at me frank @. fking123
...harness. If you're putting an EX motor in an LX car (or other way around) you'll also need to change the header "o2 sensor is in a different spot", AC pump bracket and AC pump. I put a 93 EX in a 90 ...
...motor mount locations are as follows: Front Center - Left - Right - Rear Center. If you are replacing this 90-91 engine with a 92-93 you will need to reuse your AC compressor and it's bracket, the ...
...harness connector to the blower motor Fig. 5: Unfasten the blower plate housing screws Remove the assembly from the housing. Fig. 6: Lift away the blower plate housing for access to the blower motor ...
motor: Intake manifold Engine Wiring Harness Distributor Exhaust manifold (header) Air Conditioner bracket and Air Conditioner Compressor Keep your current ECU in the car. Put your transmission on the
91 Loyale, 4-wheel drive, and put it in my car. The car would not start. I put a new water pump on it, but did not mess with the timing belts in any way. Why is my car not starting? I checked the fuel
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions