Questions & Answers for: handwheel loose sewing machine

...loose it disengages the handwheel from the shaft so your needlebar won't go up and down while you wind a bobbin. Hope thats it. Good luck. lower your needle with the presser bar behind the machine. ...

...stitch is loose Remove the thread from the machine. Raise the presser foot. Turn the handwheel until the take-up lever is at it's highest position. Set the upper tension to 5. Re-thread the

...continue to turn the handwheel to raise the needle. Pull on the end of the needle thread and a loop of bobbin thread should come up. make sure there is no lint or loose thread in the bobbin ...

handwheel to increase the belt's tension, then tighten the motor-mounting screws and check the tension. The belt should flex no more than 1/2 inch (12 mm). If it is too loose, increase the tension

...loose oil it again & let it set another couple of hoursthen try to turn the handwheel again like beforeif that doesn't work then get a can of penetrating oil, & use that,, then wait a ...

loose or broken on the inside of the machine.the name & model number of the machine is not shown, if the machine is mechanical it probably has a handwheel clutch,, make sure the smaller inner knob

...handwheel, the shank that drives the needles doesn't rise. It seems as if it's disconnected from whatever drives it up and down. sounds like the machine needs to be check, to see if ...

...handwheel is doing or not doing and ask them if the machine is worth fixing. because there could be a broken part or just a part that has come loose or maybe the machine may just need some type of ...

loose threads...looks very clean. I did look at the belt that is attached to the handwheel. It is not broken or stretched out, but it does look a little old and dry-looking. The handwheel is tightened

...Cleaned the bobbin & the needle moves up and down until I start to sew then it made a grinding noise and now even though it powers up the needle will not move up or down LOOSE HANDWHEEL ...