Question about Viking High Speed Tools: Sanders - 20,000 RPM. 90 psi. 4 cfm. Air In
...sander. # Do not hold small pieces by hand. Use a jig for pieces that are difficult to hold securely Wear safety glasses or a face shield. May even wear a dust mask depending on material your working ...
Question about Viking High Speed Tools: Sanders - 20,000 RPM. 90 psi. 4 cfm. Air In
...4- not enough air volume/pressure to run the sander. You probably need to spray some lube as above & see if that will get it to work. Also turn the sander part by hand. Rick air throttle valve ...
Question about Viking High Speed Tools: Sanders - 20,000 RPM. 90 psi. 4 cfm. Air In
...hand held orbital sander belt not rotating properly I was just about to do some sanding with a hand held orbital sander (bosch 150w) and it worked for a second, then the belt inside started turning ...
...sander and mine is doing the same thing. I replaced the motor start capacitor and it did not fix it. If you turn the switch on and give the belt a big push does it start?? Watch your hand does ...
...hand sander won't turn on I had been running the sander for a little while turned it off to adjust the plywood I was working with and went to turn the sander back on and it would not turn on. a ...
fix sander Will start run slow then trips breaker You likely have something bound up or a bad bearing. Take the belt off and turn things by hand to verify they work smoothly
Question about 414551 J-4200A Industrial Disc Belt Sander / Finisher
...HAND SANDER is easy to assemble. It's well made, easy on the eyes, properly designed and manufactured but still left me feeling that there was probably a better way to go about the drywall job I had ...
Question about 414551 J-4200A Industrial Disc Belt Sander / Finisher
...Sander? Power sanders are really helpful tools that help the sanding job done in fewer minutes but usually takes hours by hand. The amount of effort requires while removing old peeling paint depends ...
Question about 414551 J-4200A Industrial Disc Belt Sander / Finisher
...sander with a hand and another hand will give pressure on the sander for working well and maintaining the center of the work. Now, the sander is ready for using. When the sandpaper will be needed to ...
Usually answered in minutes!
317 Questions
162 Questions
122 Questions