Questions & Answers for: hand brake yukon stuck

...Yukon while driving ,then my yukons engine shut off and it pulled real hard to the left.Brake fluid level is good,brake pads and rotors are good. Your ABS sensor in the front left wheel is bad, this ...

...hand brake switch req's checking to ensure it is being pushed to off position when h/brak is down ? so fluid level low is the obviouse 1st check as fluid will displace from reservoir as pads wear low ...

...yukon e brake is stuck. Grab a small hammer, slide under the back wheels, you will see the wire and springs on the inside of either brake disc. Tap forward on each. Once free'd up, drown it in PB or ...

My 99 GMC yukon driver side brake caliber is red hot. What might be the problem? sounds like the caliber is stuck , might be a bad seal i would take cailber off and check it or have a mechanic check

pull up on your parking brake pedal with your hand when light comes on. if this makes it go out u will need to adjust the parking brake switch under the pedal. or replace pedal spring that holds it up

Gmc yukon stuck in park. 2003 Gmc yukon stuck in park. possible brake switch not sending signal to shifter solenoid to allow shifter movement. possible broken shifter knob/relay rod in shifter ...

...yukon put into 4 wheel drive and then shifted back to 2 wheel drive. days later I heard a noise, brakes are great, i think it is stuck in 4 wheel drive the most probable cause is the front diff ...

hand brake lamp on instrument panel keeps flashing regardless of the brake paddle, brake paddle switch is ok The light is not only used to indicate that the parking brake is on, but also indicates ...

brake light switch Hi for for your brake light on there some options low Brake Fluid, Hand brake switch, Low pads.

...brake lights stay on on my 2003 Yukon SLT 4x4 I just change the brakes check under the brake pedal,theres a switch connected to that ( press pedal switch on ) this could be stuck on through bleeding ...