motor runs but chuck doesnt turn sounds to me as iff your metal gear rod from the armature has broken
Question about 13618 - 2G 18V Brute Tough Cordless Hammer Drill/Driver with core
Motor runs but chuck doesn't turn. Is this something I can fix with a part? Chech and see if the top selector is fully engaged, if it is, then you will have to replace the gearbox assembly. Any Bosch ...
Question about 13618 - 2G 18V Brute Tough Cordless Hammer Drill/Driver with core
Motor runs,chuck turns. Sound like metal grinding. you can hold and stop the chuck, no power. Stopped working after using hammerdrill. Clutch stopped working a long time ago. Screws were stripped by ...
Question about 13618 - 2G 18V Brute Tough Cordless Hammer Drill/Driver with core
hilti te5 motor turning but not driving chuck While the drill is running grab the chuck and turn it by hand. If you here a grinding noise that tells you the rotor gear is stripped.
Question about 13618 - 2G 18V Brute Tough Cordless Hammer Drill/Driver with core
...hammer drills and they've both developed the same problem. When the drills are in high speed ( 2 ) they will both stall under load. The motor keeps running, but the gearbox's / chucks stops turning. ...
Question about 18v Battery Hammer Drill Dcd950 Dc925
...drill handle for leverage, apply steady, even, strong pressure until it breaks free. Using this method usually bends the part of the chuck in the vice making it useless. Another ...
Question about 1199VSR 8.5 Amp 1/2 Inch Hammer Drill
drill runs until pressure is applied to the bit. then the motor cotinues to run but the chuck stops spinning. It sounds like the gears themself are stripped. On the inside of the drill right behind ...
Hammer drill wont drive My Craftsman hammer drill broke when drilling recently. The motor runs like normal, but the chuck will not turn. Anything I can do? It sounds like the gear inside sheared the ...
Question about Professional 1/2 in. 8.0 amp Hammer Drill - 28129
drill firmly on its side on a firm flat surface with the chuck overhanging the edge fit the chuck key and position it just above the horizontal and to the left. Striking the key downwards sharply with
Question about Professional 1/2 in. 8.0 amp Hammer Drill - 28129
My Bosch hammer drill 11224VSR runs good but the chuck doesn't turn on any of the 3 settings. What could be the problem? hi the main driver from the motor spindle is worn
Usually answered in minutes!
227 Questions
165 Questions
160 Questions
104 Questions