I am not getting any heat It is a gas heater This link may help. Not knowing what diagnostic codes you have limits what help we can give. Follow the troubleshooting guide in this link. ...
A client called and asked me to check his furnace, because it wasn't working. I replaced the glow coil. The new coil comes on but no burner ignition. Control board clicks, trys twice, then shuts down.
Goodman GMS80903BNA ignitor goes out just as gas valve opens and before ignition tried replacing ignitor suspect electrical problem with power switch check out the pressure switch........... i take it
My Goodman furnace, model GMS80903BNA, is not working. I removed the back panels and checked the pressure switch. That seems to be working fine. The exhaust inducer spins up, the igniter starts to ...
back, I knock in the Mother-Plate, then Turned ON for about 5 min. then OFF. I have a Godman Model# GMS80903BNA, it looks new, ' cause my house is New, too. The Igniter turns on, no have firing at all
power had been out and wont kick on we have power now did you remove your furnace doors? they need to be in place for the furnace to work.make sure they are in place correctly
Induced blower comes on and runs for a while then turns off. Nothing else works. Saw a fault code of "3 blinks". 3 blinks is fault with the pressure switch not working try jumping it out ...
blower runs constant,powerboard blinks 4 times take front panel off where light is and look inside there will be a chart telling you whats wrong
i have a goodman furnace mod. gms80903bna the glow bar comes on but goes out before the main gas come though just replaced the board? adjust the gas pressure on the gas valve or replace the gas valve
Question about GMS80903BNA Heater
Hi, I have a Goodman GMS80903BNA Furnace and recently what happens is that when the thermostat calls for heat the draft inducer motor starts. However, after this nothing seems to happen. I don't h
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions