Question about 1995 Sonoma
...gmc sonoma just put in new starter now only starts sometimes. it takes a few tries to get it started. it just clicks until it starts. Test your battery if it test good then replace your starter. Most ...
...GMC Sonoma 4.3 v6 Can someone explain to me where the starter is located on my truck, '92 GMC Sonoma. Also, is it held in with 4 screws or bolts? If not, how is it? bottom rear of engine on the ...
how do you change starter on 95 gmc sonoma? 4 cyl or 6> 4 cyl must remove the exhaust at manifold then the bar from engine to tranny then starter it is a tight squeeze
...GMC Sonoma won't turn over. What are the possible reasons for this? It's getting fire, gas and compression. -JM did you check your starter? solenoid fuse relay? if the engine dont turn over first ...
...GMC Sonoma starter removal This should help: http://www.s10forum.com/forum/f135/replacing-starter-soloniod-need-help-please-8991/ If you search on that site you should find some other articles to ...
Question about 2004 Sonoma
...GMC Sonoma, We have put a new starter on the truck, and a new batter, but the truck turns very slow and will not start Make sure the starter gear is not to close to the flexplate you may have to shim ...
Question about 1997 Sonoma
...GMC Sonoma SLS. Have removed exhaust from manifold but still unable to get starter out from under vehicle There are vehicles that you have to take the motor mounts off and jack up the engine to get ...
Question about 1997 Sonoma
...gmc sonoma wont start all the time has new starter and key switch Hi, just replaced the starter and key switch in our 2000 gmc sonoma automatic 700 r 4 the battery reads at 12.56 v and it has ...
Question about 1994 Sonoma
...GMC Sonoma with 4.3 motor starter don't fit flush. What wrong ? Are you sure this is the correct starter? I have never seen this ever not in 50 years of Chevy repairs. If the drive house on the ...
...GMC Sonoma replace starter. Tools needed to remove starter please. Not an easy job due to the space being tight. You need a jack, a set of axle stands, a socket set and a set of wrenches. ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions