Questions & Answers for: gmc front axle stuck

Question about 1999 Jimmy

1 Answer

...GMC Jimmy with push button 4x4. Placing the car in nutral followed by pressing the button it doesn't flash like it used to just lights up the next setup 4x4 hi. You can hear the transfer case locking ...

Ad

Question about 1997 Jimmy

2 Answers

...a hammer sometimes it will let go try that You cannot pull the front differential and drive the vehicle. The wheel bearings are tied into the front axle, and won't properly lubricate if not

Ad

Question about 1995 K1500

1 Answer

front axle on my 01 gmc sierra is actuated even when in 2wd, is it possible that the actuator could be stuck in the in position keeping the axles engaged instead of free wheeling? I would have assumed

...GMC Envoy (90K miles) seems to be stuck in a low gear when starting out all of a sudden. This happened a few days ago, it has popped out of this problem once already, but the issue returned ...

...front axle. The actuator is located under the battery tray. You will have to remove the battery and the tray to gain access to it. You could also have loose or bad vacuum hoses at the top rear of the ...

...gmc envoy 4x4 problems. 4200 vortec engine. my front diff doesnt seem to be When in 2wd my front driveshaft spins freely. When I switch from 2wd to 4wd the front driveshaft won't spin freely ...

...front of a 2004 Envoy 4WD? You have to take the wheel bearing nut off the axle and pull the bearings with it. remove tire -brake caliper and brake caliper bracket if rotor stuck spray penetrating ...

...GMC Jimmy is stuck in neutral kept going into 4 wheel drive put it into 2 wheel drive now its stuck in neutral Sounds like you will need to check the front axle vacuum actuator (should be located ...

...gmc sanoma 4x4 when I turn in 2 wheel drive it seems to pull like 4x4 is still engauged.but it shows to be in 2 wheel.any suggestions thanks the front axle actuator is stuck engaged. the actuator is ...

...front locked up so he thought it was the break pads he changed them and its still locked whats wrong Most likely a warped rotor and with new pads it has locked it's self up. Sticking calipers and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...