Questions & Answers for: gmc clutch 94

Question about 1994 Sierra

1 Answer

Clutch wont engage I have a 94 gmc k1500 with a 5.7. Replaced the clutch, master, slave and line. I have bled the system and still have about an inch inch and half of play at the top of pedal. With ...

Ad

GMC Yukon air conditioner on, it doesn't get cold, the AC clutch doesn't engage. There is no voltage at the two 2-wire connections leading to the AC. The light in the dash indicates the AC is on &

Ad

Question about 2002 Cavalier Coupe

1 Answer

gmc sierra is hard to get in gear once the truck is warmed up. When it first starts and runs it shift perfectly check the fluid in the slave cyclinder,it looks like a brake fluid tank, you need to use

Question about 1994 Sierra

2 Answers

...clutch GMC G30 6.5 TD ACDelco#15-4680 GM#15028400 1999 and up big-nut fan clutch 6009991, big nut water pump amg#5745093, ac delco# 251-603. The 6.2 and the 6.5 waterpump do share the same basic ...

...clutch master cylrnder my 94 gmc sierra 6.5 td keeps blowing the clutch master cylinder. it cracks the plastic housing just above where the hose connects. ive tried replacing the slave also but ive ...

my 94 sububan some time slip even i just replaced trans fluid and filter.What causing it.how can i relace all the trans fluid ? If you had just replaced the filter and fluid and it was running very ...

Question about 1994 Suburban

1 Answer

...gmc safari van code 67; cruse control - switch circuit problems or air conditioner AC pressure sensor - circuit problems or torque converter clutch (TCC) solenoid. this info looked up in my GM Code ...

...94 k2500 with a 4l60e TRANSMISSION SHIFTS GOOD INTO 1ST AND 2ND BUT WHEN IT GOES TO GO INTO DRIVE THE ENGINE REVESE UP AND WONT SHIFT INTO GEAR Dropped pan and fluid was clean no debris at all just ...

gmc c1500 4.3 no start, engine turns over, got gas but don't have. everything in thge ignition is new, got power at the coil Place a spark plug tester in your number #1 ignition lead and confirm spark

94 yukon blew the lines out put it back together and the torque converter is extremely hot what could of gone wrong The clutch in the torque converter could be slipping causing excessive heat. What is

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...