Questions & Answers for: gm truck spark plug boot

spark plug wires are stuck You need a special tool when they are stuck on, it's like a long pair of neddle noise plyers with sides that grabs the wire by the boot evenly, but twist them loose from the

Ad

Question about 2002 Grand Prix

1 Answer

Spark Plug Wire Removal I have one spark plug wire that needs to be replaced but I don't know how to remove the wire how do you do that normal spark plug wires just pull off. thet might have a clip ...

Ad

spark plug caps to replace spark plugs in 2002 GMC Yukon This is normal for the boots to be stuck on it is a very tight fit to begin with and the heat that is generated around them cause them to stick

...spark plug wires off of the spark plugs sometimes they can get stuck on prety good if they have been on for a while. Try twisting them like you either screwing or unscrewing the spark plug. You will ...

...spark plug boot puller Try to turn the wire before pulling on it to break the seal.I use an alignment shim from (early gm upper control arm) with a 1/4 inch bolt about 4 inches long fits around the ...

Question about 2005 Avalanche

2 Answers

...spark plug wire is stuck on top of the spark plug so how would i go about getting it off so i can take the spark plug out? Spray some wd-40 or other lubricant in the hole where the wire was in. Use ...

Question about 1999 Aurora

1 Answer

...spark plug socket and ratchet. Without the Removal Tool, you'll wind up in a mental institution. GM used to sell a similar tool but since Oldsmobile has passed on to the great beyond, you'll ...

Question about 1999 Expedition

1 Answer

...spark plug a piece of the coil boot is stuck over the #3 spark plug ('99 triton 5.4 v8) how can we get it out to remove the spark plug, we cant get a new coil on because of this piece and we ...

...spark plug wire pliers" that grip around the boot and then remove it with a twisting and pulling motion. Worst case scenario is you ruin the wire attached to the spark plug. Then you get a new set of ...

...Gap For 2.4L-- Allow a gap of 1.27 mm (0.050 in). Tighten the spark plugs to 18 N·m (13 lb ft). Apply dielectric lubricant GM P/N 12345579 (Canadian P/N 1974984 or equivalent to the insulator

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...