Questions & Answers for: glue plastic

Ad

husky plastic gas tank what kind of glue will fix it Polyurethane glue might stick to the plastic, but fuel is likely to loosen the glue. Best fix is to replace the tank(s) casting entirely. Good luck

Ad

Question about Prestige Home

1 Answer

glue to the rubber/plastic stoppers and hold them into position on the toilet seat lid till the glue sets, just takes about 20 seconds... Then the toilet seat will be good to go again...pardon my pun.

Ad

...glue it back on! Bad idea ....now that control remains depressed and the oven won't work at all!! Help!! Not to much can repair / remove the crazy type glues once they are applied to plastics ...

Question about Vacuums

1 Answer

glue kenmore vacuum plastic The plastic swivel where the metal hose attaches to the brush motor part cracked then completely broke. I need to know what type of glue will work. Should I use an epoxy? I

...glue the plastic parts to the metal beneath them? I hope there won't be a problem with such a solution since I have a lot og ganga ash in my car and it might prevent the glue from sticking if ...

Question about Villeta 3912ST Satine/Polished Brass Showerhead, Easy Clean 400

1 Answer

an epoxy glue, but it didn't hold. Any ideas. If you could find out what kind of plastic the head is made of try that glue that works on that type of plastic. Different glues work on different plastic

Question about Villeta 3912ST Satine/Polished Brass Showerhead, Easy Clean 400

1 Answer

...glue from fingers so ok or not after drying? - Some glues say ingredient may cause cancer. == Given above, need to know which plastic used, which glues work, which work with w/o chemical hazard since ...

plastic solvent glue usually comes in tubes. Make sure the tray is dry and at room temperature before putting the glue on. It should slightly melt the plastic and fuse it together. I would put another

Question about Refrigerator White Fridge & Freezer Handle Set - 5304485330

1 Answer

...Glue from plastic. Wipe the glue away with the solvent-dampened rag. Remove cured Gorilla Glue from a hard plastic surface with a razor knife or chisel. Clean residue from the surface using a spray ...

...and plastic.(tube glue not superglue it's like a gel) thin amount of glue locks it in place or a blob of glue turns into a rubber seal. also stops cracking from same crack. used it myself works

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Garden Experts

roeb

Level 3 Expert

811 Answers

john h

Level 3 Expert

20245 Answers

Marvin
Marvin

Level 3 Expert

84625 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...