Questions & Answers for: glass cooktop burner working

...glass cooktop A platic box that eggs came in touched a hot burner on my glass top. It won't come off. didi you try heating the burner slightly to soften the plastic a bit before trying to scrape off, ...

glass CookTop. One of the burner element (double) no more works. The cricuit breaker trips again and again. Is there some fuse that i can locate to fix this problem. It sounds like the burner needs to

...glass top on the Jenn air gas cooktop. I can't seem to get the glass top off. Is it glued down? well usually you have to remove the knobs. thentake all of the caps off of the burners. sometimes there ...

...Glass GE Profile Cooktop Burner popping The right burner that toggles from small to large size is not working. I noticed that the rod that the nob attaches to is not pulled up. When I pull it up in ...

...correct one. Reverse the process for reassembly. Good Luck i have glass GE profile cooktop with 4 knob. My problem is with one knob. This knob dosn't work. Is this any posible way to fix this

...glass cooktop electric burners go on and off burners go on and off and occasonially don't even come on, Kenmore glass electric cooktop model 629.42025. not sure if i should replace each cartridge ...

...glass top cooktop- burners do not heat, indicator lights do work If none of the burners are working but the pilot light does you are having a power problem and only getting 120 volts to it. Check the ...

...Glass cooktop 2 out of 4 burners not working I have an Amana smoked glass smooth cooktop (not sure of the model) that two of the four burners suddenly went on...the same day. It is both of the back ...

...ugly the glass for the cooktop? if that is the case you should know the cost just for the glass is $470.00 plus the service call and labor it's going to be at least $600 to replace the glass ...

...glass cooktop from my GE Cooktop JGP962TEC2WW, however, I think I need to remove the 2 screws from each burner base in order to do this. Problem is, I cannot get the screws out as they appeared to be ...