Questions & Answers for: generac idle control

...generac) and is 100% dependent on engine speed. There is a screw under the tank when your looking in from the recoil side. It controls the governor arm. Screw it in and it incresses the rpm, out ...

generac guardian ultra source battery is good. trace wire to relay in control box, no power to on off switch in front, wont start. can jump at starter to spin over but no power to fuel solenoid. 15000

...idle control, unit dies -- fuse is blown. If start, run and shutdown, next attempt to start fails (no response when pushing start button) - fuse is blown again. Any ideas? The auto speed control is ...

generac 4000XL. engine dies when idle control switch is thrown. I have a generac 4000XL. Starts and runs fine, UNTIL I throw the idle control switch to ''on''. When I throw the switch, the engine dies

Generac 4000xl high idle, idle control not working. I have a Generac 4000xl that sat for about a year. I replaced the oil, filter, fuel, charged battery etc. The unit starts and runs but my idle ...

gererator turns off when i turn the idle control switch on generac 7500 the governor or or the idle coil assy needs to be replaced. Possible that a adjustment could be made.

...generac 10000 elx model 9801-1 125v at idle and 150v at operating speed. new control board #96476, new power regulator #92769 still same results. is engine running at 3600 to 3700 rpm at full load. ...

idle control button. Generac 17.5 kW If its blowing with nothing plugged in, then you have a short near whatever it is feeding. Usually 10amp is for the 12V circuit. If its blowing with things plugged

My generac 4000xl runs rich when I turn the idle control switch off Diesel generator set faults solutions: www.dieselgeneratortech.com

...generac gp7000e have throttle control? Mine drops to a low idle (which reduces my voltage) but does not ramp up unless I am pulling over 5 Amps. But I do not see a throttle control? ...