Questions & Answers for: ge washer reset knob

Washer will not get off of the "Final Spin" stage, even if the load size knob is turned to reset. I tried to let the machine run on Final spin to see if it would reset itself, but that did not work. I

ge washer? mine is stuck on spin. thank you I have a GE WBSR3000GWS Model and it stopped spinning at one point as well. My service guy came out and did the procedure below and reset it with in minutes

ge profile top loader "fill" knob broken The capacity knob broke as I was turning it to the "reset". Do we take off the entire panel to try to fix? If it came off cleanly no, but if the glue they ...

GE washer won't spin but drains water correctly. ahow do I reset the off balance switch? Check the lid switch for continuity. Bad lid switch= no spin. You could also have a reset in one of the knobs. ...

GE WHDRR418 top load washer won't spin at high speed; the washer does the complete cycle, and agitates in both directions and does physically spin, but it will not go into the 'high speed' spin that ...

...I need to reset my front loader (adora GE) How do I do that? Unplug unit, Plug back in.Rotate control knob to correct Model number.Press and hold start key till beep is heard,press power key to ...

...washer stops doesn't rinse and spin Hello Try reseting the machine.Unplug power for 60 seconds. Plug back in,then turn knob to reset.Then try another load of wash or finish the one that is stuck ...

...GE Hydrowave washer I included a service manual there also. Hopefully you will be able to reset it. If you can't a fuse may need to be replaced. I included details there also. Thanks for using

...ge wjre5550h1ww wont spin. everything else work up to that point Might need to be reset. To Reset the Inverter board on the motor push the timer knob in so the washer is idle or if digital have the ...

...GE washer is stuck on a Stain cycle and it will not start. I can change the cycle, but it will not start and if I turn power off and on again, it goes back to Stain cycle. We've held the start/pause ...