Questions & Answers for: garbage disposal air switch problems

...the main obviously works or you wouldn't be able to wash anything. you need a new timer switch assy. You may find the problem in your garbage disposer and / or the passage opening to the

...either have to let the pan air dry, or use a hair dryer to get all the moisture off the sensor. Ours locked up periodically until I replumbed the drain, disconnecting it from the garbage

air in the tube increases. When the pressure reaches a certain level, it activates the switch, shuts off the water, and signals the timer to begin the agitate cycle. If the switch is defective, it may

...don't have an air-gap it may be hooked up to the garbage disposal and if you don't have a high loop in your drain hose the water can run back into the dishwasher especially if the disposal backs

...air gap into the garbage disposer is clogged. Remove and clean the hose. Make sure to reattach the hose before starting the dishwasher. Note: If you recently had a garbage disposer installed, it is ...

...air gap into the garbage disposer is clogged. Remove and clean the hose. Make sure to reattach the hose before starting the dishwasher. Note: If you recently had a garbage disposer installed, it is ...

...disposal, at the T-junction in the drain lines. Unless your plumbing is *very* old, the drain lines should be PVC with large nuts that can be removed by hand. Use a bucket below the junction as you ...

...down to run the garbage disposal. Upon release it turns off rather than running until depressed again. I've had it 4 weeks. make sure the airline is secure, a slight air leak could cause this ...

...air gap into the garbage disposer is clogged. Remove and clean the hose. Make sure to reattach the hose before starting the dishwasher. Note: If you recently had a garbage disposer installed, it is ...

my aircondition cuts power from time to time and the pipes won't sweat as well so it does not chill inside The will rise high and noisy after few minutes of switching it on and and the noise will cut ...