Questions & Answers for: g28 sensor

sensor/G28 engine speed sensor. The cam sensors are fine, I've checked them out and had an oscilloscope on them. I need to know the location of this sensor and if replacing this would cure this fault?

Sensor (G28) loose Engine Speed Sensor (G28) faulty Possible Solutions Check Engine Speed Sensor (G28) Special Notes The Engine Speed Sensor (G28) is also used as a reference sensor for the crankshaft

...sensor g28 is on the side of the block. The flywheel have offset bolts so can only be fitted in the correct position. The best way to set tdc is with a special tool that goes into the side of the ...

...sensor g28 is on the side of the block. The flywheel have offset bolts so can only be fitted in the correct position. The best way to set tdc is with a special tool that goes into the side of the ...

...sensor g28 is on the side of the block. The flywheel have offset bolts so can only be fitted in the correct position. The best way to set tdc is with a special tool that goes into the side of the ...

vw polo 1.6i 2006 cuts out when the temperature is at 90 degrees and after ten minutes it restarts Hi. this sounds like a g28 cranks sensor issue.

vw polo 1.6 when temperature is at 90 degrees it cuts out and after ten minuts restarts. Hi. This sounds like a g28 crank sensor issue.

cam position sensor implausible signal awx engine code tdi runs flat,no power CHANGE THE G28 CRANCSHAFT AND THE G40 CAMSHAFT SENSORS!!!!

...known Possible Causes Idle Switch Open or Open Circuit Throttle Valve sticks and won't close Speed Impuls from Engine Speed Sensor (G28) recognized Possible Solutions Perform Throttle Body ...

...Sensor G28 <<< BINGO REAL NAME FOUND, HARD TO DO.2.0l On the front lower left side of the cylinder block, next to the oil separator. Refer to (see more...) Removing and installing. Refer to ...