Questions & Answers for: fuse location blower fan suburban

...fuse box for blower, or look inside engine compartment fire wall usually passenger side, You will see the cylinder part of the blower motor, if fuse is not bad, try taping the cylinder part of the ...

circuits . Did you check the BLOWER fuse 40amp located in the under hood fuse / relay box And the HVAC /ECAS fuse 10amp in the under hood fuse box ? Plus HVAC I fuse 10amp located in the I/P fuse box

fan not working from switch All fuses are good I jumped wire at blower and blower is working Heater blower motor resister is bad, replace, located under dash above heater motor. check relay and blower

...fan is even located? it sounds like you have a crappy connection on the rear blower. i think your blower is on the right side rear. remove the panels and the blower is right in your face. check for ...

...blower fuse under the hood and htr/ac and hvac1 fuse left side of the dash. three things left to check, using test light see if you have power at motor with key and switch on,if you do replace ...

...blower ,my fan stop blowing Probably isn't you blower that is bad...they rarely die, check fuses, relays, and resistror, test motor before going thru the hassle of possibly replacing a good motor to ...

blower fan stopped working. The fuse tested good. It is either the blower fan or wiring assembly right ? Is there an easy way to test either ? check the resistor i think it's a 7 way connector located

...is a blower, how do you replace it? Does air flow from any locations? Can you hear the fan running? The blower is above where the passengers right foot would be. It is removed from the inside the

...fuse to stop it, the swicth is bad in dash were the swicth goses off and 1 though 4 or 5 the blower motor resistor relay assembly may be bad, it is located on the blower motor housing front blower ...

...fuse box under the rear seat.. Could also be a blower control module; this is located inside the right rear quarter panel. Go to trailvoy.com, they have excellent instructions for how to remove the ...