...fuel pressure regulator diaphram causing fuel to be sucked into intake manifold. the other is a bad wire crimp joint for main earths which is in main wiring loom under injector rail on left bank ...
fuel pressure when this happens are there any O2 sensor codes also? or fuel trim codes? if low is pump at fault? or is fuel filter blocked? check fuel pressure regulator on rear of inlet manifold left
...sensor on top of gearbox. The break I fixed in my 2003 Leon 1.6SX was in the loom under battery tray. My symptoms were no speedo working, and erratic fuel guage (particulary when under 1/2 full). I ...
...fuel pressure if above does not work! the fuel cut valve may be the culprit. if it is the maf sensor, you can go to any auto parts store and buy a can of maf sensor spray to clean it. just follow ...
...fuel filter and clean the egr valve. Can you help please code p0238 refers to manifold absolute pressure (MAP) sensor A TC system --high input===causes --wiring short to positive --MAP sensor---ECM ...
...tip and leads into the wire loom.But the 02 sensor will turn the check engine light on.other intake components like sensors, fuel injectors and the fuel-pressure regulator.should be checked.
...pressure sensor? Pressure is 151 kpa with or without map sensor This is most likely due to bad wires to the map sensor, Follow the wires from the sensor back to the loom and check the ground ...
...sensor wire resistance xj 6 engine is running very rich .the coolant sensor is working ok Resistance in the wires going to the acu is 2 ohm, coolant sensor disconnected.the wires going into the loom ...
Question about 2007 4Runner
...fuel pump I would fit an original replacement to avoid pressure issues. ...
...fuel pressure. Leaking/contaminated fuel injectors. Leaking fuel pressure regulator. Low fuel pressure or running out of fuel. Vapor recovery system. Induction System: Air leaks after the mass air ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions