...lower control arm bushing that usually goes, is the front one. The rear one doesn't usually go, it is horizontally mounted. The front one for some reason is vertical. The control arm must be removed, ...
...Lower front suspension lower arm with a jack while making sure lower ball joint is seated in spindle bore. Install the lower ball joint attaching nut and tighten to 113-153 Nm (82-113 lb-ft). Install ...
...body of the vehicle. Remove the reinforcement. 7)Remove the pivot bolt attaching the front bushing of the lower control arm to the front suspension cradle crossmember. 8)Remove the lower control
...front lower control arm and remove the remaining 2 bolts, if working on the rear lower control arm, remove the 2 bolts holding the arm in place and install the new control arm. An alignment is ...
...front lower control arms. A quick inspection of the front end and you should be able to tell if the links are bad, bar is broken, or the lower control arm bushings are separated. If the rear bushings ...
lower control arm off my 01 stratus SAFELY RAISE SUPPORT VECHICLE ON JACK STANDS. MAKE VECHICLE SITTING ON LEVEL SOLID GROUND. REMOVE FRONT WHEELS , REMOVE HEAT SHIELD, IF EQUIPPED WITH 15 INCH WHEELS
Question about 1999 Malibu
...front lower control arm bushing is mounted vertically. REMOVAL AND INSTALLATION Some special tools are required to perform this operation including, a front hub spindle removal tool and a suitable ...
Question about 2011 Patriot
...lower front arm step by step out. (not doing back in or photos) Raise and support the vehicle. (Refer to Vehicle Quick Reference/Hoisting - Standard Procedure) TIRE AND WHEEL MOUNTING TIRE AND WHEEL ...
Question about 2011 Patriot
...front lower control arm rear drop bracket all I need is the drop bracket where can I find one These? https://www.4wheelparts.com/b/suspension/control-arm-drop-bracket/_/N-cm7od Specialist suppliers ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions