front tire and that the wobble was out of control. If I took my hands off the handle bars it would begin to wobble and get progressively worse to a danger level. They said it was tire wear. I bought a
front end into the air and turn left and right. Stiff? Loosen the cap nut until the handlebars move freely. Now it could also be that the steering stem bearings need a bit of grease. Some dis-assembly
...handlebars. Can/should the wiring be routed under the gas tank? If so how is the tank removed? Just a suggestion,no offense.I'd check out how much of the frame top rail that the tanks mount to.you ...
...handlebars and seat is always far more harsh than my ducati with ohlins fitted. i have settings at fairly soft but still dont have the same comfort as the ducati. does anyone have any ideas or ...
Question about 2000 FXD Dyna Super Glide
...handlebars on the bike, install the front master cylinder and use a piece of stiff wire and run a "fake" brake line down to the caliper. Then, measure the length of the "fake" brake line to get the ...
...handlebars are stiff to turn right,very stiff .this happened after i parked up.any clues My guss is the steering bearing has become stiff, raise the front wheel of the ground turn from left to right ...
Question about 2008 FLHR Road king
...handlebars on my 09 road king. How does the throttle sensor come out? TWIST GRIP SENSOR 4.10 REMOVAL Remove the left side saddlebag, remove the left side cover, remove the main fuse, (Do not remove ...
Question about 2008 FLHR Road king
...front wheel to the fork. Ensure that the wheel is properly aligned and tighten the nuts securely. Next, attach the handlebars to the stem. Make sure that they are properly aligned and tighten the ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions