Questions & Answers for: fountain pump wire colors

I have a flo-master xp/xp2 - just repaired but runs stop-hi-lo instead of stop-lo-hi -- so filter cycles run on hi instead of lo. How to I fix this? thanks I think the wiring to the motor is incorrect

...pump, you can use silicone filled wire splices to repair the cord. These are used for submerged well pumps and consist of a heat shrink splice tube that has a silicone liner. You slip the sleeve over ...

...wire the pump for 110 vs. the default of 220 volts? All motors are different depending on what plant they came from, when they were made and so on. The wire plate will have letters or numbers on it ...

...pump that has a cut cord with brown, blue, yellow with green stripe wires inside a black sheath. We have another cord we would like to splice with the pond cord. the wire colors are black, white, ...

...pump motor has three terminals one marked c one marked h one marked L which wire colors go where Thank you for posting your question here on Fixya.com. Your wire harness should have 4 wires then: ...

We have a Catalina spa with and executive 56 7.0 BHP pump that is leaking? must it be replaced or repaired? and how would one do either? Yes it needs to be repaired. Water leaking around electrical ...

...pump runs on high insted of low. Switch the black & red wires, normally these are connected to the speed ports of the motor. But.... be careful! Electricity is color blind and does not care what ...

Need color code wiring for Coleman Horizon 400 topside controller RJ connector good luck, post one if you ever find one.

...and need a wire diagram for an ignition switch i bought a new switch from ford new holland and their wire colors are different from the wiring that i have to work with. any solutions Hope this