Questions & Answers for: ford truck starter 3 terminal

...starter on 2001 ford f350 dually (7.3 l powerstroke) replacing starter on f350 Starter Removal & Installation 1. Disconnect the positive and negative battery cables. 2. Raise and safely support ...

Ad

...ford expedition STARTER - REMOVAL & INSTALLATION 4.2L, 4.6L, 5.4L and 6.8L Engines Fig. 1 Remove the starter terminal cover Fig. 2 Remove the cables from the starter terminals Fig. 3 If equipped, ...

Ad

Question about 2003 F350 Super Duty DRW SuperCab

1 Answer

...3. If the starter has a heat shield, remove it. Remove the protective plastic cap and disconnect the wirring from terminals on the starter solenoid. 4. Remove the starter motor mounting bolts and ...

Question about 1984 Bronco II

2 Answers

...Ford used a starter relay that mounted on the fender well,which will have most wires hooked to the relay itself on the battery side of the circuit.,only the big cable runs on down to the starter ...

Question about 1984 Bronco II

1 Answer

...starter. 3. Smaller wire (from ignition switch) goes on smaller terminal in the middle. 4. Big red wire goes to big terminal farthest from the starter motor. If this doesn't make sense, please get ...

Question about 1997 Expedition

3 Answers

...FORD-EXPEDITION-STARTER-46L-1997-1998-NEW_160456310228.html And this is removal manual: Starter Removal & Installation 1. Disconnect the negative battery cable. 2. Raise and safely support the ...

Question about 2001 Expedition

1 Answer

...Ford Excursion, Expedition, Lincoln Navigator 2000-2005StarterREMOVAL & INSTALLATION TESTING & TROUBLESHOOTING PrintRemoval & InstallationBefore servicing the vehicle, refer to the ...

...ford starter solenoid and install it in the line to the starter connect the big solenoid terminals from battery on one side to the starter solenoid energizer terminal on the other side, use wire to ...

starter on Triton 5.4 Ford 250 1998 1. Disconnect the battery ground cable. 2. Raise and support the vehicle. 3. Remove the starter motor solenoid terminal cover. 4. Remove the nut and remove the wire

Ford F-150 has 3.8 volts on the S terminal of my starter solenoid when the ignition switch is to OFF. I it should be at zero. Mine stays at 3.8 put it in drive it goes to zero. But will shoot to 12..5

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...