...rear drums set up? why did you bleed the brakes. when only when you installed new pads? 1992 Ford E350-same brake concern, pedal goes to floor! Replaced master cylinder, brake booster, frt pads and ...
Ford Bronco II spongy brake pedal My brakes were working fine until the rear steel brake line developed a leak. After replacing the line and bleeding the brakes several times, the pedal became spongy ...
...ford focus 4dr sedan...No rear brake lights, upper one on trunk works, all other lights work, as well as signals which are the same bulb. Bulbs are fine, fuses are fine. What is it?? I have heard ...
ford thunderbird supercharged v-6 You need to replace the round Ball (accumulator ball). It's not holding pressure. You have front brake only. Is the pedal hard as a rock, the red brake light stays on
...rear brakes 1996 model either with a brake spoon or by backing up at 15mph and hitting the brakes hard, because most have auto ajusters that ratchet up when you back up and hit the brakes. if that ...
...Ford Mustang GT rear brake problem Right rear outside pad not moving when brakes are applied. Found lower slide pin stuck, removed it, cleaned it, and put antiseize on it. Both slide pins now work ...
...brakes.I broke the rear line and now I can't get any brake peddle.Loosened line where we hooked to brake and let it drain until fluid ran free.still no peddleWhen engine is not running brakes is ...
Question about 1999 Mustang Cobra
Ford Ranger had no pedal changed brake booster and master cylinder bled Breaks several times now pedal is as hard as a rock! I Tried to drive it the brakes work but when I hit them hard they locked up
Question about 2001 Focus
...ford focus. I can turn the rear wheel by hand when the brake pedal is being applied. i was having a hard time adjudting the parking brake, worked that out (sort of).when I had the car on the hoist I ...
rear drum brakes, and the calipers in the front of this 1998 Ford ranger 2 wheel drive and have bleed them and there is still not brakes.... please help..... I am at my wits end on this problem.... If
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions