1986 ford 2.3 1986 ford ranger 2.3 it has a problem it runs good when it is cold but when it gets warmed up it want run it miss real bad try changing the condenser
...Ford Ranger XLT miss fires in blowing snow I drive down the road on a cold day with the wind blowing and when i come to a spot where snow is blowing across the road it will miss fire. This only ...
...Ford Ranger no heat 97 Ford Ranger 4.0 4x4 with A/C standard Transmission. With the Heat selector switch turned to heat, the A/C compressors still cycles like the A/C is still on. If I disconnect the ...
on acceleration it it misses through 1st 2nd 3rd gear.......runs better when cold... might be egr... disconnected the hose to valve.. still lacks power... put new carb gaskets... thought there might ...
...cold miss is most likely the upper intake gaskets...they are just rubber seals in all actuality and is very common problem on the 4.0 ltr (im guessing thats whats in it) and the miss or skip at ...
...ford ranger edge regular cab 3.0 Liter 6 Cyl.. 2 problems...Replaced Plugs and wires. Truck idles rough (especially after running for awhile) and misses when driving. You can feel the hesitation. ...
...Ford Ranger 2.3 Have a 92 ranger that runs on 1 cylinder when you first crank it for a few seconds (longer when the engine is cold) then it clears up, have changed out, crank shaft sensor, mass air ...
missing cut out 94 ranger stalls out when cold what motor and are there any codes
Question about 1993 Ranger SuperCab
ranger with a 3.0 starts fine when cold but stalls when the engine warms up. it will stall as soon as I touch the throttle and not restart. I have spark and fuel pressure on the injector rail. changed
Question about 2001 Ranger
Ford Ranger XLT 3.0, 4 door Can anyone help with these issues listed below? Need Help Please. 2001 Ford 3.0 Ranger, replaced Coil pack, replaced the following, IAC, TAC, DPFE, MAF, NEW PCM, new Plugs,
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
