Questions & Answers for: ford ranger ignition speed sensor

Question about 2000 Ranger SuperCab

1 Answer

...Ford Expedition XLT, 155,000 miles ABS light comes on at times and stays on, if i turn off ignition and restart it goes off. Could that be a sensor? This is definately a wheel speed sensor. Most ...

Ad

Question about 1996 Explorer

2 Answers

...ford ranger idol problems Hello to all out there. I have a 1997 ford ranger that the engine lopes while or idling or idles erratically does any one have any ideas? MIGHT be the tps The TPS is ...

Ad

...Ranger 95 Ford Ranger 3.0 - code P0340 keeps re-occurring. What is the most common cause for this code to show, and where is the cam sensor located on this engine? Hi, the cam shaft sensor will be ...

Question about 1998 Ranger SuperCab

1 Answer

FORD RANGER ENGINE PROBLEM STARTS WILL NOT ACCCELLERATE AND DIES CHANGED CRANK SENSER NO HELP CHECKED COIL PACKS AND FUEL PRESSURE OK I THINK BOOKS VERY POOR DESCRIBING WHERE TO LOOK CODE READER SAYS ...

ranger seems to be having a fuel? problem? It runs fine on initial startup, however after it is warmed up I lose power when I am idling for a long period of time or if I am coasting at highway speeds,

...ford ranger 2.9 runs gr8 in morning runs cuts out an stalls at red lights after it cools down starts-ups 20mins replaced both internal and external fuel pumps and both filters pressure ...

Question about 1986 Ranger 2WD

1 Answer

...FORD RANGER stalls while driving - differant speeds ...differant miles ...no rhyme or reason to it - cranks right back up ...can even pop clutch and cut it back on. Already replaced Ignition Start ...

Question about 1993 Ranger SuperCab

1 Answer

...ford RANGER 2.3l will idle fine but wont rev up. falls flat. have checked spark on all plugs, has new ignition module, checked timing, has exhaust flow out tail pipe, have cleaned mas airflow sensor, ...

speed between 50 and 55 mph the truck will occasianally feel like it studders for a second then continues with a smooth ride for a few minutes then it happens again. At higher or lower speeds I do not

...ford ranger no --The purpose of the crank position sensor is to notify the ECM when the piston is in the correct position to create a spark for the cylinder. regardless of the rpms of the engine, it ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...