Questions & Answers for: ford pid codes

Question about 1999 Explorer

2 Answers

...Ford Explorer have you checked your filters ?? air, mass meter, any hose burnt , cracked, ?? also there is a throttle position sensor that is in charge of opening and closing the intake, if thats ...

Ad

...codes. if you have ascaan tool that can check pids you need to view the cmp pid and the ipr pid if ipr is below 500 it will not run or the cam shaft sensor might have went bad there is a recall on ...

Ad

Question about 2000 Stratus

1 Answer

...PID is greater than 2.45 volts with a non-matching fuel gauge. Application Key On Engine Off Key On Engine Running Continuous Memory Ranger GO to Pinpoint Test HX . All others Refer to the Workshop ...

Question about 2000 Stratus

1 Answer

...Ford recommends CHEVRON TECHRON fuel system cleaner. Run tank low, put in cleaner, use best gas you can find,avoid your frequent brand. 02-06-2006 06:19 PM #2 TXFO Not Special Enough Join Date Jul ...

Question about 2008 F 450 Super Duty

1 Answer

...codes, or it is only a partial key read or no key read, the IC will send a message to the PCM to not ground the starter relay solenoid coil and not allow fuel injector operation. The anti-theft ...

...past experience with a 98 explprer. Bauer edition (key pad on door) but can't seem to find the code to unlock my door You need a NGS (Ford factory scan tool) They can access the RAP KEYCODE

...ford.html no they are not related ! Are there any cracks in the rubber hose from air cleaner to throttle body ! That could cause the P1121 air entering after mass air flow sensor ! P1121 - Throttle ...

Question about 1998 Windstar

1 Answer

the proper scanner you can read that pid. Also, check for fuel injector pulse, engine cranking. Check for applicable trouble codes. To check codes, yourself, at the least, you need an obd2 code reader

than 49.05% (2.44 volts) with a LOAD PID less than 30% indicates a hard fault. Do you know what scan data on a scan tool is ? How to Install Replace Throttle Position Sensor TPS 2001 Ford Ranger Buy..

ford-trucks.com .. B1352 Ignition Key-In Circuit Failure CTM REFER to Section 413-09 . PINPOINT TEST C: THE KEY-IN-IGNITION CHIME DOES NOT OPERATE CORRECTLY CONDITIONS DETAILS/RESULTS/ACTIONS C1 CHECK

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...