96 mustang gt tranny problem i have a 96 gt and my tranny was strong then all of a sudden my 2 gear wouldnt lock in just grinds then i shifted first and it worked fine and now the shifter just moves ...
ford mustang, 3.8L v6. stick shift. i just replaced the headgasket and thermostat and radiator, and now theres a new problem. all my gears are slipping, it starts fine, but when you put it in gear and
1996 Ford T Bird obd codes Have code po161 which is oxygen sensor code along with codes, po713-trans hot, po1000-od cycle, p1270-overspeed, p1746-pressure solenoid, and p1747-pressure solenoid, which ...
...mustang will not shift up when driving. I have a 1966 Mustang that will not up-shift while driving. I trying not to take the vehicle to an expensive transmission shop. Any suggestions? The ...
...ford mustang (automatic) Check and see if your brake lights are functioning. If they are not then look for fuse #9 to be burned out. The shift interlock on these cars is dependent of brake light ...
Hard shift from 1st to 2nd. Engine rpm goes to 3000. I have a similar problem. when i press the gas in first gear(automatic-transmission)the engin rpm goes up to 3000 but there is no power and then it
MUSTANG GT WITH A 5 SPEED MANUAL TRANSMISSION AND IT MADE A LOUD POPPING SOUND WHILE SHIFTING FROM FIRST TO SECOND GEAR AND NOW SEEMS TO BE IN FIRST GEAR NO MATTER WHERE YOU POSITION THE SHIFTER youve
...ford mustang shifting problems Can only start car when gear shift is in reverse position sounds like an automatic? the position selector/which is a plastic sort of triangle that has wires ...
...ford mustang the gears are not shifting properly, sometimes it wont shift unless shut car off and put it in the gear and restart car and there is high pitched noise while trying to shift in gears Did ...
location of shift solenoid Location of transmission shift solenoid on 2002 ford exploer, 4.6
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions