Questions & Answers for: ford fusion egr valve

.went off ..now it is back on again..what could it be The most likely cause is the tank cap coming loose or not being tightened properly. Another cause for this issue is the EGR valve becoming clogged

shifts hard when taking off and passing,will stall going up a hill then **** and take off EGR Valve a possible. If you have vacuum lines going to it ,disconnect, plug, and see if problem goes away.

...ford fusion 80,000 miles. recently I have had a jerking problem from the rear. The first time this happened I thought someone hit me from behind. I am only going to guess You may have a bad EGR ...

...EGR valve opens the exhaust back pressure changes and the DPFE sensor informs the processor of this information. If the sensor isn't reading a change when the EGR valve is turned on through the ...

...EGR valve and Idle air control valve or smog pump if equipped." I have no idea what any of that means, or what a solution to this is. Any feedback would be great! THANK YOUU! Read this post on ...

ford fusion S I have an unstable and low idle when in drive/reverse. When just holding the brake, it remains a problem, but if I engage the parking brake, the idle stables out at around normal. I have

...ford Fusion S Rough Idling when in Drive/Reverse I have an unstable and low idle when in drive/reverse. When just holding the brake, it remains a problem, but if I engage the parking brake, the idle ...

...Ford Fusion show a P0400 code EXHAUST GAS RECIRCULATION - EGR VALVE - EITHER THE VALVE OR THE TUBE MAY BE CLOGGED. THERE'S A LINK ATTACHED WITH A PAGE THAT EXPLAINS THE CODE - GIVES YOU THE OPTION TO ...

is that I can replace? If it is a belt.... there is only one serpentine belt. Does it go away after it warms up? In the 90's Ford had a problem with the EGR valves that would "hoot" until it warmed up

Where is EGR valve for 2010 Ford Fusion located 2010 Ford Fusion EGR valve location https://m.youtube.com/watch?v=Ik0zCgl5bPY Hope this helps