working. Any Ideas? Chris Most at the time its a brake/cruise control swich located above brake pedal.Its might be shorted or pedal not pushing swich back enough for cruise to work.Anyway the swich is
...f250 brake controler will not work i installed a new brake controler with the plug that goes under the dash im not getting 12v(19v from the battery) to the controler and when i put 12v to the ...
Question about 2002 F250 Super Duty SuperCab
...ford f250 and the cruise control quit working If a gas engine, check the switch on top of the brake master cylinder (cruise control deactivation switch) if it is leaking brake fluid it will cause too ...
...F250 cruise control not working Is the truck an automatic or standard? Commonly the failure has to do with either the brake pedal switch or the clutch pedal switch. What have you checked out so far? ...
Question about 2002 F250 Super Duty SuperCab
...turn signals, and cruise control stopped working all the sudden well fords are bad about brake light switches going bad... although that will not explain the turn signals. do the hazard lights
ford f250 electric brake won't work. Everything else on the 7 way plug works (signals running lights brake lights etc.) When the brakes are pushed or the controler is moved forward the volts are going
...Ford F250. Trailer brakes are good and have a new break controller. I do have voltage on the 7 pin connector when break is applied, the voltage starts at about 9 volts and goes down to about 3 the ...
Question about 2002 F250 Super Duty SuperCab
Ford f250 super duty V10 cruise control doesn't work. Ford f250 super duty V10 cruise control doesn't work. WOULD CHECK BRAKE SWITCH FIRST AS THESE HAVE A HIGH FAILURE RATE.
Question about 2001 F250 Super Duty Super Cab
...brake pressure like it had initially. not sure what I have hooked up with easy disconnect as will use in F250 or will switch to Suburban. having problems with both vehicles, and wondering if a short ...
Question about 2002 Ford F250 Truck Super Duty Crew Cab Power Window Regulator wit
Ford F250 Cruise Control not working I have replaced the sensor on the brake pedal on the interior of the truck, the cruse deactivation switch as well at the other sensor on the master cylinder. Still
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions