...ford excursion with a v10 motor The IAT (Intake Air Temperture) is the sensor that measures the temp of the incoming air to the engine, it is either in the rubber hose to the engine from the air ...
...Ford Excursion V10 6.8L When hooked up to a computer shows that cyc 6 is not working replaced the rotor and plug. When hooked up still readying that cyc 6 is not working. Replaced again think new one ...
...Ford Excursion V10 6.8 L When hooked up to a computer shows that cyc 6 is not working. Replaced rotor and plug still reads that the cyc 6 is not working so replaced again thinking the new was bad. ...
...v10 excursion would crank over but not start. 2000 v10 excursion would crank over but not start and the theft light was blinking. I let it sit for a few a used a second key and it started. Could the ...
...ford excursion v10 Need to know what the fuel pressure specification on 2000 ford excursion v10? Fuel pressure for your 2000 Excursion is 35-45psi with key on and engine off, with engine running the ...
...Excursion 6.8 V10, hard start, high idle, code P1288 KOEO, and KOER, no memory codes, with temp gauge in normal range scan data reads 20 deg F, suspect CHT sensors looking for sensor location. CHT ...
ford excursion v10 have changed radiator also water pump Begin with the basics.... INSPECT COOLANT LEVEL, Low ????,PRESSURE TEST SYSTEM, PRESSURE TEST RADIATOR/EXPANSION TANK CAP, INSPECT DRIVE BELT(s
Question about 2001 Excursion
v10 cranks but will not start. If I use starting fluid it will start and stay running. Any ideas? does not show any error codes. If I shut it off and restart its fine but if I let it sit for a few ...
Question about 2001 Excursion
...ford excursion with a 6.8 v10 drive 20 mn, coolant temp guage just pops up all the way to the top and the oil temp light comes on at the same time and the engine all but quits running. . Sounds like ...
Question about 2000 Excursion
...ford excursion 6.8l v10 will start on first try when cold, but it takes 2-3 times of cranking when engine is warm. run fault codes indicate ambient temp sensor , maf,vaf or engine coolant temp sensor ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions