Questions & Answers for: ford edge rust problems

Ford vehicle. Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa. If it was just the

...edge of the rim, but be careful not to rap it to hard, as you might dent the rim.It won't hurt to grind a little bit, just enough to remove the rust. I do it all the time.Hope I could help out. my ...

...rust along the outer edge of the disk as this can cause the noise also if their is a build up of rust running along the outer edge of disk then gently tap this off with small hammer then with the ...

...ford escort trying to remove rear brake drum. How the heck do you remove them? There are two philips head screws that are rusted on bad ,thinking I cant get anything fixed til I get them out any ...

...Ford Escort inner door catch no longer opens driver's door obviously something has gone inside the door panel and outside door lock is getting stiff to unlock with key although still unlocks at the ...

...Edge that appears to be gear lube. Checking to see of this problem has occurred regularly with this vehicle. You should see if you are still under warranty. If there is a lingering problem Ford may ...

...ford crown vic There are core plugs all over the engine, where is it leaking? The freeze plugs are located around the middle of the engine block. If you suspect one to be leaking coolant, you can ...

need to replace rear brakes drum wont come off Rear brake drums become difficult to remove because the backing plate of the drum becomes rusted to the axle hub. Another problem that can occur, is ...

ford f250 new 4x4 hub will not slide on to axle Old hub goes in and out no problem new hub on drivers side went in no probem but passenger side new hub will not slide into place. Everything lines up ...

...Ford f 150 dome lights blink on 2000 is before LEDs were widely used, so let's assume these are incandescent lamps. Since you said "lights" (not "light") there must be more than one, and they must be ...